Anycubic Photon Printer Owners 造訪社團 » EVA

Okay so Discovery number one with the 3D resin printer when you're cleaning with your paper towels pay attention to the second cleaning you may do to your parts and the paper towels that you used if there's no resin in them straighten them out and let the isopropyl alcohol evaporate out you can reuse those towels this picture is all of the paper towels that I have been using since I started with this machine that is these only had isopropyl alcohol. And I have reused these paper towels over ten times now.

翻譯年糕

Hey thanks for adding me! A question for the group. I am planning to buy a photon today, But all of my prints will be from my own cad designs to be used as masters to make molds from. So because of this the colour of the resin is irrelevant to me, as well as strength and durabilty, Can anyone recommend a resin that offers the best print times and fidelity/detail quality?

翻譯年糕

Hi there, i have annoying residues when using Resinaway. Before that i used IPA which works great and evaporate quickly. Then i read a lot of praising about Resinaway. Got that and my first try left a lot of white residues on my print after curing.

Then i read that this is because of bad cleaning. So i bought an Ultrasonic-Cleaner. So i make a prewash with Resinaway and after that a clean ultrasonic bath also with Resinaway. Then i let the print dry for a while. Compared to IPA, it doesn´t evaporate much and leaves an oily film on the print.

Now even after cleaning with an Ultrasonic-Cleaner, i get this white leftovers which kind of ruin a transparent print. How can i solve this? Does it makes sense to wash the print with water after cleaning with Resinaway, but before curing?

翻譯年糕

Hey Evan Daes, look what I gone an done, so awesome.

翻譯年糕

And another of Evan Daes amazing designs. Anycubic white

翻譯年糕

And second set done, awesome simply awesome Evan you rock. I lost a wheel down the sink when I was washing them lol. I have no idea what the ghosting of the wheels is from.

翻譯年糕

Hey Evans Evan Daes set number 1 number 2 is printing. Anycubic green. Absolutely fantastic designs, thank you

翻譯年糕

Help. I have been printing flat on the plate with good results, but decided to try elevated automatic support to see if it would work. The parts looked great on the tray, but the support was fused to the parts and impossible to remove, even with needle nose.

What settings work for CTB for the support that goes under the part and is peel-offable with minimal marks and distortion of the part?

翻譯年糕

Could someone please help me run Voxels-Ops, or at least point me in the right direction. Do I need to install an interpreter?

While I've done a fair amount of computer programming, that was C++, and it's been almost 20 years since I did anything except Mastercam.

The readme file assumes a level of relevant knowledge that I just don't have.

翻譯年糕

If you are new to the group or new to 3D printing I thought I'd take the time to shoot a short video dedicated to failure.
Whether this is your hobby or your profession unfortunately failure is an option! Fortunately you're running a duplicator machine unfortunately you can duplicate the failure. Fortunately because you can duplicate the failure you can eventually isolate the failure and move on. When the failures happened welcome them because they may be teaching you how to evade that failure on a future much more important project. I consider failure the steps of a stairway ascending to knowledge!

翻譯年糕