My third print of the test cube and it is the best yet, but still has major fail. I started with exposure time of 10 seconds, did this twice so last night I thought I'd up it to 12 seconds (Using newly shipped resin dated Sep 2018) and this is by far the best print. The lattice structure looks near perfect as does one of the internal banners, the other banner not good at all. Any ideas? Thank you for your patience in helping me learn this process. Bob
我的測試立方體的第三個列印, 它是最好的, 但仍然有很大的失敗. 我從曝光時間10秒開始, 昨晚做了兩次, 我想我會提高到12秒(使用2018年九月2018日的樹脂), 這是迄今為止最好的列印. 晶格結構看起來近乎完美, 內部旗幟之一, 另一個橫幅根本不好. 有甚麼想法嗎? 感謝您的耐心幫助我學習這個過程. 鮑勃·鮑伯
·
查看原文
·
為此翻譯評分
Sen Kun
2019-01-12 23:06:50
Bob Leschyna
2019-01-12 23:09:46
Sen Kun
2019-01-12 23:09:52
Sen Kun
2019-01-12 23:10:55
Bob Leschyna
2019-01-12 23:12:29
Julia von Pfaler
2019-01-12 23:46:58
Bob Leschyna
2019-01-13 00:09:07
Bob Leschyna
2019-01-13 00:10:12
Robert Silvers
2019-01-13 12:15:06
Bob Leschyna
2019-01-13 13:01:16
Fred Breton
2019-01-13 13:01:20
Fred Breton
2019-01-13 13:04:22
Bob Leschyna
2019-01-13 22:40:53
Sen Kun
2019-01-14 00:22:00
