I'm having an issue with my prints (monocure rapid grey) sticking TOO well to the plate. I broke my spatula, and have had to resort to a craft knife blade to remove the prints and even then I still have bits sticking that I have to scrape off. I haven't sanded, I use a drop of platebond because I've had trouble in the past with the print separating from the plate, and I'm printing outside, overnight in Australia when temps are getting as low as 8-9 degrees celsius. I thought resin had to be heated in winter or it wouldn't work? Any ideas? Especially if anyone has found a safe alternative to a craft blade without potentially amputating their fingers! I tried a metal paint scraper but it's not sharp enough to get under the edge of the print.
翻譯年糕
Stefan Giudici
2019-07-29 11:50:23
Mike Fatchett
2019-07-29 11:50:31
Seona van der Pol
2019-07-29 11:52:32
Scott Pavlich
2019-07-29 11:55:45
Seona van der Pol
2019-07-29 12:13:56
Adam Nock
2019-07-29 12:19:35
Rigo Arevalo
2019-07-29 12:27:34
Jarrod Smith
2019-07-29 20:54:57
Seona van der Pol
2019-07-29 21:15:14
