Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Aaron Strome
2019-07-27 17:53:35

So the test print finally made it. It must have been the leveling. But now this weird stuff is clung to it. Anyone seen this before or know why it happened? I used the compiled test cube from the AnyCubic website.

翻譯年糕

Aaron Strome
2019-07-27 18:04:55

Aaron Strome
2019-07-27 18:49:29

原文網址 Aaron Strome
2019-07-27 07:24:57

wish me luck. ? just started the test cube. 5hr 42 mins

翻譯年糕

Gavin Paull
2019-07-27 07:34:01

Gavin Paull
2019-07-27 07:34:20

Aaron Strome
2019-07-27 07:35:21

Mika Vienonen
2019-07-27 07:53:11

Aaron Strome
2019-07-27 08:15:50

Travis McGeathy
2019-07-27 08:38:52

Aaron Strome
2019-07-27 08:40:06

Aaron Strome
2019-07-27 08:54:48

Tauri Icenogle
2019-07-27 10:24:30

Aaron Strome
2019-07-27 10:44:34

Aaron Strome
2019-07-27 11:34:55

Aaron Strome
2019-07-27 11:47:42

Aaron Strome
2019-07-27 11:54:48

Aaron Strome
2019-07-27 13:58:27

Ced Ric
2019-07-27 15:27:12

原文網址 Aaron Strome
2019-07-27 06:53:53

does anyone have a quick link for the torture test cube.? i want to test this out properly and of coarse my sd card was dead. on a side note... is there a way of determining the amount of resin the print takes.?

翻譯年糕

Fred Bey
2019-07-27 06:59:39

原文網址 Aaron Strome
2019-07-27 05:11:43

Hi everyone. just got my Photon and was so stocked until i put in the USB and it doesn't read it.. went to the page to get the slicer and it say 404 page not found.. has anyone figured out how to be able to use this printer.?

翻譯年糕

Aaron Strome
2019-07-27 05:13:48

Leonard Grubbs
2019-07-27 05:28:36