Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I created my first hollow models. What is the best material to use to fill those holes. I know that Chitubox printed out fillers but I don't think those will be the best solution.

翻譯年糕

Photon-Stops printing after 1st layer and reboots continued. This happened 3 times tonight. Submitted a ticket to AC. Took the STL file and sliced it with AC Slicer and it is working. I have been using Chitubox. One thing I have noticed is that the Chitubox slicer files are much larger in size??? This file that is printing now is 27k, the Chitu file size was 109k???? Using the latest version of Chit....Maybe it is time to go back to 1.4 chitu........

翻譯年糕

First run with Ele gray and Tenacious. Love it. The bows can be flexed. I cut one in half by accident. Only issue is that they are about 10 percent too big. I forgot to scale them down to 25mm. Whoops! They will be fine though. I just poured the Tenacious in with what I had in the vat so I have no clue what the proportion is. I would guess 30/40 percent Tenacious.

翻譯年糕

Failure after 1st layer or so. Printer stops printing and I assume reboots and you end up at the print/tools/system main menu. I unplugged the Photon and plugged it back in and reloaded the photon file on the usb....NOT the one that came with it. Photon would not read a 128gb usb drive that it had been seeing ok. Even had a hard time reading the 8gb one. Finally saw the drive. went up some levels and back down, selected a different print then exited, back into print and started printing again. So far so good. I have not seen this since updating to the latest firmware. I smell a big bad bug.

翻譯年糕

Hot off the press! Black guard from Miguel Zavala . Elegoo Gray. .02 looks pretty good to me. Uncured. A bit blurry in spots. Print one in .05 just to compare. For our campaign .05 is fine.

翻譯年糕

New Photon Firmware.

翻譯年糕

Suggestions for Resins that are more forgiving for DND Minis. I have a couple of swordsmen that have had their blades removed by a nasty fall LOL. I am using Elegoo Grey and it is very similar to AC Grey. Maybe I am over exposing but the prints come out great.

I read the Suriya tennacious and ELE grey 30/70 mix was pretty good. Any other suggestions?

翻譯年糕

Switching to transparent resin:

I thought I had posted this earlier but I guess Murphy came along.

I have been printing gray resin but want to try some clear. Getting all the resin out of the vat is always a challenge. Should I just pour in some IPA and let it set for a while or wipe it out good and go?

翻譯年糕

FEP material. I ordered 3 ft of material from McMaster-Carr. used the part number I found on some group. I got the material. I did not have any protective material on any side. There was a roller mark about 8 to 10 inches down from one edge and tons of pock marks. There is no way I would consider using thing stuff. I called them and described what I got. They said, that is no good let me send you out 3 more feet. They did, looks better than the first chunk but still no protective coating, same roller marks and pits and pock marks all over. Maybe other have had better luck.

翻譯年糕

I have been printing in AC grey and want to try some transparent prints. What is the best way to get rid of the grey resin? I don't want any mixing. IPA soak for a bit?

翻譯年糕