Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Sharing a mistake I made while rushing. I only put a single support on the bottom of this orc's shield so it moved around until it got to the arm which was much better supported. In this case, it fits right in on an orc. ;) This learn by example is brought to you by the letter O and the number 1.

翻譯年糕

Hey folks. Wondering what folks think of this modification to resolve z-wobble issues. Of those that have used this, is it a reliabale fix? Are folks doing any other better fixes?

翻譯年糕

Ok, so odd question, but is there a place to store models folks have already added supports and successfully printed? Man, that could potentially save a lot of time. ;) Perhaps just the STL files so folks can slice the files with their own resins settings?

翻譯年糕

Anyone know where this brass nut is supposed to be on the Photon? Support is asking me to replace it, but I don't see it anywhere. I assume it should be near the z axis/motor as they sent me a replacement screw and motor. Thanks in advance.

翻譯年糕

So I replaced my z axis and motor and re-leveled several times using the Flint Read method. Every time the resin is on the FEP, not the build plate. I am printing an exact photon file have printed half a dozen times with no issues prior to changing the z axis and motor.
Anyone else run into this and/or have a solution?
Prior to changing the z axis and motor, I had levelled a couple times and had not had any issue - resin always stuck to the plate like it is supposed to. With AC support, it appears Mia, who was helping earlier is gone, and a new person, Zoe, is basically having me start all over. I've taken my machine apart to tighten and loosen things 3-4 times so far with the first round of support and had done so a couple other times before I even contacted them. Ugh.

翻譯年糕

Does anyone have the custom build plate files for use in the B9 Creator? I thought someone had posted this not too long ago, but I cannot find it. It'd be good to get those in our files section as well. I am having trouble following the instructions and the example on the Moai forums also includes an STL file - which is not in B9's instructions.

翻譯年糕

Ok, so I just replaced the z axis rod and motor. Is it supposed to make this noise? The original one did not sound like this. Is it the motor, or do I need to grease the rod?

翻譯年糕

Saw someone posted a similar approach a while back so I thought I would make my own resin draining setup.

翻譯年糕

When folks change the resin settings spreadsheet, Please make sure to leave the sort by brand and color for ease of use.

翻譯年糕

Anyone had this issue...
So I performed the steps for the z-wobble video.
Now when I print, it gets to about layer 20-30 and the print job just stops and the screen goes back to the main menu.
I can see cured resin on the build plate and I can hear the ripping sound between base layers.
Also, the fan is louder than it was before doing the steps, I may just need to confirm I didn't get any wires in the way of the fan.
Thoughts?

翻譯年糕