Anycubic Photon Printer Owners 造訪社團 » 用戶發文

So, my photon is losing steps. I'm guessing the driver just needs to be adjusted or the stepper is dying. Anybody experience this? I put a ticket in with C.S.

翻譯年糕

Hey, quick question. I just got done a print. 3 pcs in total. 2 smaller pieces made it through, but the larger one didn't. The smaller pieces are bracelet clasps'. the other one was just a rectangle plate with some half circles cut into it. i tried laying the plate down and on it's side and laying down flat... both times printed straight to bed, but at some point the plate broke free from the bed. I'm thinking A.) the z=0 doesn't perm. save on my machine and maybe i need to bump the z=0 each time i start the printer, B.) even though its a fairly thin piece( .1" thick) maybe I need to hollow it so the suction doesn't pull it off the platform, or C.) maybe a few adjustments on the settings (.04/14/1/65/6). This is using Bucktown Polymers, which the resin seems to be fairly easy to print with.

翻譯年糕

testing bucktown with some black metallic dye

翻譯年糕

My Bucktown order came today... Still waiting on my dye though....

翻譯年糕

Hey everyone, On the Photon, is it possible to change the z-steps and adjust the screens scale ratio using some sort of M command. my z is a little short and my xy is slightly oversized

翻譯年糕

Fail once.. fail twice... Third try... Thumbs up

翻譯年糕

Quick pics of what got printed yesterday... Overall I'm satisfied with he results.

翻譯年糕

bad photo, great results

翻譯年糕

attempt number 2 with the Photon. I think I found my issue with the first print. trying a different model, so lets see how it goes. I had good build plate adhesion (supports where all attached. the model never really bonded to the supports... so a) support wasn't big enough, b) I didn't tighten the set screw for the build platform. / I zeroed the platform and tightened the screw and made the rad of the support another .1 so we shall see how it goes. anycubic resin w/ Group time sheet recommendation.

翻譯年糕

sorry for the crap photo. first attempt. looks like the model separated from the supports. (build platform had all of its supports) the circle should be on the opposite side.. so i guess it broke and continued to print with plastic floating.. and maybe when the the build platform would come back down it was able to pick up the model enough to work another layer. iunno.. More supports??? I think this had 20% and printed flat.. maybe add angle? support tips? what size should they be ?

翻譯年糕