Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi!
How long did you cure resin under sun? I ask mainly becouse it's 16:50 and don't know if I can sand prints in the evening, when the sun goes down :P

翻譯年糕

Hi,

I was trying hole in Chitubox and tell me, how big they need to pour out resin from hollowed object? And, how big need be vent for air intake?

My first try was 1,8mm for both, but vent was to low and resin stay on they level. I have not comparison that this is good or not, in hole sizes term :P

翻譯年糕

Hi!

Can I add some pigment to UV resin? I have foggy-translucent resin and they annoying me... I can't see through them and can't se details. I made hollow print and that was killing my eyes :P

翻譯年糕

It worked out much better than I expected! Box made of foamcore sheet :P

翻譯年糕

Hello
I have a question for you. I think that everyone here know that UV resins are quite expensive, especially original ones like Formlabs resins.

What do you think, how much cheaper resins need to be, to make DLP/SLA printers more common? How much resin should cost for you to classify them as "cheap" but still good enough to casual printing?

翻譯年糕

Hello,
I have question for you. I am searching power LED in HIGHER wavelenght than resins 405nm up to 500nm (yes, higher wavelenghts had small effect on resins too). In another words, you know any power LED without UV and blue light in their spectrum?

EDIT

I am thinking about LEDs like "warm white" but without UV and blue in spectrum, not single color LED, like red for example.

翻譯年糕

Hello,

I just wondering, how many ml of resin in bath do you need to start printing? For example, 50ml is enough? I haven't printer on desk so I can't measure that on my own.

翻譯年糕