Anycubic Photon Printer Owners 造訪社團 » 用戶發文

A little help please. I recently switched back to anycubic resin and I'm having a hard time printing. A flat spot on this turret is warped even though I angled it. I reoriented it and the same thing. It's weird that at certain places, it will print the supports but not connect them. When I reoriented the sculpt, I added a few seconds to the cure time and the peg didn't print. Here are pics of orientation and settings.
Working with anycubic black.

翻譯年糕

What slicer program do you guys use in order to add supports?

翻譯年糕

So many times this printer frustrates the hell out of me. Then again, sometimes it impresses the hell out of me. Printed this ring to test detail because I was board. Pretty good for one of the cheapest printers on the market. Printed at .01

翻譯年糕

Does this seem normal to you? I zeroed it like I always do but this seems weird. I wonder if it is damaged from yesterday when it lost zero and kept a grinding from trying to go lower

翻譯年糕

I was just about to print something when I hit stop because I wanted to grease up my machine first. I then chose the print again, left the room to wash my hands and when I walked back, the machine was grinding trying to go below the zero. FEP has an indentation on it. Screen is ok and I tested the UV which works luckily. Why did my machine lose its zero?

翻譯年糕

What causes this?

是甚麼原因?

· 查看原文 · 為此翻譯評分

Anyone thought of this for FEP replacement?

翻譯年糕

Is this FEP still good or should I change it?

翻譯年糕

Warped one on the botton is with supports. The one on the top is not using supports. I thought supports were needed for a better quality print? What am I doing wrong with the supports?
Note, other pieces are worse with warpage and unusable

翻譯年糕

What causes the first few layers to do this on flat surfaces?

翻譯年糕