Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Had a original bug in the system. The print survived

翻譯年糕

Can the resin become contaminated and stop sticking to the build plate?

翻譯年糕

Has anyone tried the Monocure FEP Sheets? And what are the advantages/disadvantages between 100 and 200 micron thick sheets?

翻譯年糕

Now I was printing models successfully but now nothing is sticking to the plate. It started mid way through a bottle of cubic Green with settings
layer 0.05
normal 15
off 6.5
bottom exposure 80
bottom layer 8

I have cleaned the plate after each job and due to the failed print in the resin tray I have re-cleaned the tray after each failure. I have also re-leveld the plate and still it has failed.

Should I sand my plate or is there something else to do before I go to that irreversible step?

翻譯年糕

I have just started a new bottle of resin (same green as in the starter bottle) I have not changed any of the settings but nothing is forming. I did shake the bottle. I first thought it might have been the plate getting knocked off but I have re-levelled that as some models were forming on the plate but now none are. I am about to go to a earlier sliced file to see if that prints out

翻譯年糕

Has anyone used the Anycubic clear resin? If so feedback on results and settings used would be great

翻譯年糕

What is a good budget program to edit stl files?

翻譯年糕

For those that have had problems with the slicer program crashing while creating support I have found that if the orientation of the model is changed it can create the support in the new orientation (X,Y, or Z axis) You may have to try a couple of different times. I just tried 90 and 180 on a few problematic models and then I could make supports without crashing

And Yes I have been using the newest version of the slicer and it still crashes

翻譯年糕

A question on the slicer program. I know I can rescale/resize a object, move it rotate it. Is there any way to mirror a item (example change a figure so instead of it holding a weapon in the right arm it is mirrored to be holding in their left arm), cut a larger project or to hollow out a item for printing?

翻譯年糕

Either I am doing something wrong or I have a serious failure with the UV light.

Using a new USB stick I have sliced a file with no problems. The printer reads the file and starts printing except that every print results in - nothing except resin dripping off the plate.

I am using the sample green resin and everything on default.
Am I doing something simple wrong or is the UV projector dead out of the box?

翻譯年糕