Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Making decent progress on Punisher. Hard to control the spray on a small print like this but very happy with the results so far, especially compared to just using spray cans before this. Starting up my next print, Thanos, but it'll take a lot longer because I need to print the torso and legs on my cr-10s because they're too big for the Photon. At .1mm, it's going to be a while. Fortunately, it should be a lot easier to paint since it comes in pieces!

翻譯年糕

Turns out my airbrush was bent which was why painting was looking terrible! Got a different airbrush (same air compressor) and it's working great. Just started painting a punisher print.

翻譯年糕

Looks pretty good! Just got to cure and sand. Got an airbrush kit for Christmas so this will be my first test with it.

翻譯年糕

Getting ready to UV cure in the sun. I printed this one standing upright to maximize size. My printer is finally somewhat working again. Still seem to need to relevel after each print. Also having the issue where it’s harder to remove from the plate than normal but not too bad and the supports feel like they’re almost cured already which made it difficult to snip off without a little damage to the model. Odd since it’s in the basement and not near a window.

Silent hill nurses on Thingiverse (this was model 3 in the set of 4)

翻譯年糕

This needed more time in the alcohol wash but from arms length, looked ready. Any idea what the lines are about? This was printed flat on the build plate

Settings
.05
15 secs
Base 8 layers
6.5 on/off

翻譯年糕

For people that have sanded their build plates:

Have you ever had a print that was damn near impossible to remove? I had printed some small figures and left them overnight like I've done in the past but when I eventually got around to taking them off I ended up having to use a chisel and lightly re-sand due to scratches I made on the build plate. I was worried about prints after that but the next print came off easy although I did catch it soon after the print finished. Just wondering if my leave overnight technique days are over or just a fluke?

翻譯年糕

Hey success! Hard to tell from the night vision baby monitor but the test cube is printing for me. I have been unable to print for a little while and was thinking something was really wrong since I was using files I knew were good (they printed for me before with the same resin) So I broke down and finally sanded the build plate which I was hoping to avoid. Also releveled (again), vigorously shook the resin and didn’t care if there were some mini bubbles. One of those steps seemed to fix it though I’m guessing the sanding since I was getting a lot of failed prints with just hardened resin on the FEP.

翻譯年糕

When do you know that you need to change out the LCD screen? Been unable to get anything to print lately, even the test cube (that NEVER fails for me!) as well as files I’ve successfully printed before. The layer left on the FEP which I just changed out is looking thinner than previous fails but I do see a light when I ask the machine to show test exposure in the menu.

翻譯年糕

Unfortunately I dropped one arm and the magic bit/finger tips broke off. Working on the cape now but had to break up into 4 pieces to fit in the small print bed.

翻譯年糕

So far only 1 successful print. Been having issues with support printing fine but no model. I'm guessing it has to do with something I'm doing in the slicer because I tried the sample file after a few failed prints and it came out perfect.

Settings for this one are
Layer Thickness: 0.025
Normal Exposure: 10
Off Time: 6.5
Bottom Exposure: 50
Bottom Layer: 8

File from
https://www.myminifactory.com/…/3d-print-captain-america-av…

翻譯年糕