Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi all I'm sure it's been asked before but is there a alternative to photon slicer software. I keep getting the same fail. 50% of the time. My print runs the full time but stop printing at a random level. I slice again and again.. its hit or miss with me. I'm fairly confident it's a software issue.

翻譯年糕

Hello all. So I finally got a pic of the problem. I am getting half prints. All goes well, print runs complete cycle. But only half the model is printed has happned many times. New usb.update firmware. Success rate is about 50% on prints. So this is what the projector does when it stops curing the resin. It seems to stop projecting to the glass. After I remove the USB and unplug power it works again.

翻譯年糕

When I get a print I love the machine. Firmware has more bugs then an old tree in the woods.
And the slicing software is about the worst. In about 50% for success rate..
Any suggestions??

翻譯年糕

I'm using.
Monocure rapid white.
Layer .05mm
Time-14
Off time-1
Bottom- 60
Layers-5.
Right from the spread sheet.
So the problem is this. Printer about a week out of box. Had about 6 successful prints.
Then it all went bad.(see pic)
First there was a shift in the print,fail.
Then I lost top 20mm of print, fail
Then I lost top 45mm of print ,fail
Then nothing at all, total fail.
No errors. Film in vat is fine. I clean between every use. Projector is sending image I have seen it.
So I'm lost. What would cause a cascaded fail in this order??

翻譯年糕

Hi all. Ok so I need some help. Out of the box worked great for about a week. I am using a 3rd party white resin and have gotten good results. Yesterday had a partial fail where the print shifted about 20mm to the left.
Next print completed but only half of object was printed. A clean horizontal cur about 45mm high.
Next print it only made about 20mm
Then nothing at all.
I am printing the same item a few times.
There is no residue on the fem film. And adhesion is not a problem.
I see no blemishes on fem film.
No error codes.
I watched the screen and it seems to be displaying the imiges.
So I'm lost??

翻譯年糕