Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Question regarding Chitu Box, does the auto supports do a good job with miniatures also what setting have people been using in it?

翻譯年糕

What size of supports do people use for miniatures when using b9creator software.

翻譯年糕

So is chitu box better than the B9 create for supports? Trying to decide if I should switch

翻譯年糕

I am trying to find a solution to keeping my photon and the resin warm. It is currently in a garage that is "heated". Quotations because it doesn't stay very warm. Today it was 45-50 F in there. I'm debating about a little space heater like this.
https://www.amazon.com/Cozy-Products-Chi…/…/ref=mp_s_a_1_12…

Do you guys think something like this would work or have any other tips. Also for reference the high today was only 20F so later in the winter we will hit below 0F.

翻譯年糕

Is it save to add supports in B9 create with 0% pen?

翻譯年糕

Another question for the group. My friend wants me to print terrain and walls with my printer for D&D. (I'm making him pay for the resin). He isn't too worried about the detail of said terrain. What is an acceptable layer hight to print in. Is something like .1 mm to thick or will it still turn out ok?

翻譯年糕

Second print was a success. Very happy with this printer so far. One question though. The small cracks in him seem really glossy, almost wet still. Did I need to soak longer in ipa or what is this from?

翻譯年糕

So this is my first attempt. Is my z axis not low enough?

翻譯年糕

Ok so I just received my Photon this week. I am trying to print my first mini with it. I used Meshmixer to change the orientation to about a 40 degree angle. Now I am trying to do supports in B9 creator. So here is where I run into a problem. I found B9 Create and B9 Creator. Create wont let me do anything unless a printer is connected, so im assuming this is not the right one. So I tried to use B9 Creator. It gives me 3 options, Layout, Slice Preview. Which is the right one. Also what is the right file type I should export from Meshmixer. Because I cant seem to find my file through B9 Creator. Thanks for any help.

翻譯年糕

So I should be getting my photon next week, but I am wondering what should I use for software to assist in my prints. I was told to download Meshmixer and I have the Photon slicer already installed. Any other software or tips to get me ready for next week. This will be my first 3D printer.

翻譯年糕