Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Not sure how it managed to do this with so few supports for the light saber, but I'm happy it managed to pull it off

翻譯年糕

Biggest print I've done so far. 100mm tall. I was going to print it at a different angle, but photon slicer wouldn't let me add supports to the back brim of the helmet, so I printed Vader on his back.

翻譯年糕

Took me exactly one week of non-stop printing Miniatures and other small items i needed to print to use up the 250ml bottle that came with my Photon. Resin is expensive but it doesn't seem to go through it super quick. I'm actually pretty happy about how so little is used. Each miniature i print is between 8ml-15ml. Making each miniature cost around 70 cents to a little over a dollar. For the quality of the prints, there is no beating it.

翻譯年糕

Not even a week with this guy and I'm cranking out the prints. This is just the miniatures, I printed a few other things with no issues. I'm really enjoying my Photon

翻譯年糕

Somehow I forgot to tighten the bed's bolt before starting my next print. I came home to the bed laying in the resin with the Z arm all the way up.... SIGH.

翻譯年糕

Any good suggestions of minimizing the surface artifacts done by the supports? I been just carefully pulling them off, i know some people snip them, does the snipping help with that at all?

翻譯年糕

No failures since the test print!

翻譯年糕

Two successful prints in a row.

翻譯年糕

Huge pain to get off the build plate, but it's so purdy

翻譯年糕