Anycubic Photon Printer Owners 造訪社團 » 用戶發文

My first non-test print failed. Resin hardened to the FEP sheet. I checked the leveling and it was off. I releveled and set the home. But when i hit the option to move to home, it goes .2mm to low. No matter how many times i level it, it won't save the home i set for the leveling. Any clues on why that is? Or should i just contact support?

翻譯年糕

I want to thank everyone that bared with me today. You all make my first day with my Photon a lot smoother. Still trying to get a good test print out. Im on the 3rd attempt. I thought the first one failed because i paused it at 8% to make sure it stuck. It did, but then the rest of the print was sticking to the vat. So i cleaned it all up and started again. Same issue. Stuck to both. Check my leveling and it was a tad to tight. I redid my home position and now the paper is loose with just light friction.

So here is hoping try #3 goes through smoothly.

Two last questions: How often do you all recommend replacing the sheet on the Vat?
Anycubic stated that you shouldn't leave the resin in the vat without printing for more that 48 hours. If i am printing continually, how often should i swap the resin? Or will it run out long before two day from continuous printing?

翻譯年糕

Test print failed, the print stuck to the vat instead of the plate. Cleaned it all up and trying again.

翻譯年糕

So, I decided to read my resin bottle AFTER I poured it in and started the test print on my brand new Photon. On a scale of 1-10, how important would it have been to shake my resin before putting it in the vat?

翻譯年糕

Supports for DLP Printing:
So, I can tell when a FDM print will need supports, im new to DLP and excuse the novice question, but with DLP, would it be safe to assume that if a FDM print would need supports a DLP print would need them too? Or does DLP have lesser or stricter needs for supports?

翻譯年糕

Test print is a go!

翻譯年糕

*started out the front window impatiently*

翻譯年糕

I just purchased my first resin printer to go along with my two FDM printers.

翻譯年糕