After a few prints I have noticed that I was getting a layer of cure resin under my tray. (I am going to say that isn't good)
Took it out, cleaned it and dried it, pour water into it and waited a few hours to see if there was any leaks. None I could find, put it back in did a full print. Went to do another, it failed so I checked under the tray and the layer was there again. Is this an issue with my FEP or the housing, or maybe this is normal?
翻譯年糕
Gerhard Wilkens
2019-01-20 00:12:31
Ben Mitchell
2019-01-20 00:13:14
Gerhard Wilkens
2019-01-20 00:14:14
Che Fielding
2019-01-20 00:14:59
Sen Kun
2019-01-20 01:51:09
