Hello people of the resin printing world. I am a new traveler to this land.
:)
Been running FDM machines for years and took the leap into resin with the photon. So far 2 prints down (including the cube that comes with it). Enough to learn I have stuff to learn. is there any guideline for creating your own supports outside of the photon software? (length vs diameter, spacing, what angles need support ect)?
Also already learned the hard way, do not clean FEP with IPA. Any other common pitfalls I should worry about?
翻譯年糕
Marcus Leander
2019-01-15 05:48:45
Will Koone
2019-01-15 05:49:59
Marcus Leander
2019-01-15 05:50:35
Will Koone
2019-01-15 05:51:46
Marcus Leander
2019-01-15 05:59:23
Will Koone
2019-01-15 06:01:37
Nemo Vilpponen
2019-01-15 06:05:31
Alex Vee
2019-01-15 06:09:24
Will Koone
2019-01-15 07:14:22
Scott Gardner
2019-01-15 07:25:46
Richard Shapiro
2019-01-15 07:40:54
Jon Piercy
2019-01-15 07:46:45
Alex Vee
2019-01-15 16:54:54
Robert Silvers
2019-01-17 14:13:58
Holden8702
2019-01-17 14:42:22
