How bad does the FEP film in the VAT need to get before it has to be changed?
I only have had this printer for a couple of day and about 6 prints
and it already looks all scratched up and foggy.
I did have one instant where a print did not stick and I used the plastic
scraper to clean the resin chips out of the VAT.
This could get rather expensive if it has to be replaced very often.
翻譯年糕
Dustin Scott
2019-01-23 05:41:08
James Twohey
2019-01-23 05:42:58
Sydnee Davidson
2019-01-23 05:47:14
Andris Drulle
2019-01-23 05:54:54
Holden8702
2019-01-23 06:07:13
Bob Heron
2019-01-23 06:25:35
Bob Heron
2019-01-23 06:26:31
Kyle Bachman
2019-01-23 06:32:46
Stefan Giudici
2019-01-23 06:38:43
Lucas Milner
2019-01-23 07:30:25
Leonard Seeney
2019-01-23 08:09:54
Robert Silvers
2019-01-23 08:15:38
Terry Reed
2019-01-23 08:33:54
Terry Reed
2019-01-23 08:41:59
Mark Markleson
2019-01-23 08:42:18
Richard Shapiro
2019-01-23 08:56:57
Valent Turkovic
2019-01-23 15:37:31
Christian Plösser
2019-01-23 20:53:56
Jim Leenan
2019-01-24 00:02:34
Jim Leenan
2019-01-24 00:05:20
Andris Drulle
2019-01-24 01:22:06
Jacopo Montalenti
2019-01-24 02:09:54
Ilja Ilmar
2019-01-24 02:11:07
Jim Leenan
2019-01-24 02:26:16
Ilja Ilmar
2019-01-24 02:28:25
Jim Leenan
2019-01-24 02:31:26
Ilja Ilmar
2019-01-24 02:33:32
Terry Reed
2019-01-24 03:32:31
Jim Leenan
2019-01-24 04:56:06
Terry Reed
2019-01-24 05:06:33
Tomasz Matuszewski
2019-01-24 05:13:45
Adam Widdowson
2019-01-24 19:32:07
Jim Leenan
2019-01-25 01:25:00
