ok last question... for now...
How accurate is the support generator on the anycubic slicer? I am slicing an Alien but it seems to be a LOT of supports. I am showing without, with light, then medium supports. Which should I go with for this? Is the auto generation something I can trust?
(this is what I was printing earlier but turned into a solid block due to the LCD not working right)
翻譯年糕
Ricardo Sebastian Ibacache Guerr
2019-02-07 05:53:52
Chris Alfstad
2019-02-07 05:54:16
Mark Wardle
2019-02-07 05:54:29
Mark Wardle
2019-02-07 05:54:41
David Marquis
2019-02-07 05:55:00
Chris Alfstad
2019-02-07 05:55:01
David Marquis
2019-02-07 05:55:40
Darren Tarbard
2019-02-07 05:55:45
Kelly Wilkins
2019-02-07 05:56:05
Kelly Wilkins
2019-02-07 05:56:57
David Marquis
2019-02-07 05:57:29
Darren Tarbard
2019-02-07 05:58:04
Jordan Geml
2019-02-07 06:02:49
Nick Williams
2019-02-07 06:17:11
Fred Breton
2019-02-07 08:16:05
Joe Broggio
2019-02-07 09:09:54
Joe Broggio
2019-02-07 09:10:40
Kelly Wilkins
2019-02-07 09:50:53
Joe Broggio
2019-02-07 09:53:20
Kelly Wilkins
2019-02-07 10:05:14
Joe Broggio
2019-02-07 10:06:16
Joe Broggio
2019-02-07 10:07:01
Kelly Wilkins
2019-02-07 10:39:28
David Marquis
2019-02-07 10:56:17
Jonathan Takagi
2019-02-07 11:00:49
