Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Keenan Beblo
2019-02-16 14:08:57

how would you guys print this? I tried at 45* angle but it failed. I tried right on the plate as is but I don't think it has enough contact area to keep itself stuck to the plate as it prints. failed about 20% in. it is hollow. its basically just a tube. I tried a raft but that was a disaster.

翻譯年糕

Sen Kun
2019-02-16 14:35:35

Dylan Hancox
2019-02-16 23:06:21

Richard Shapiro
2019-02-16 23:55:47

Philipp Maitrot
2019-02-18 15:48:09

原文網址 Keenan Beblo
2019-02-10 03:54:57

A lesson was taught today.....I have a cover for my VAT, took it off to print....forgot to screw the VAT back down!

翻譯年糕

原文網址 Keenan Beblo
2019-02-07 11:13:53

do I need supports under here? or will it do that platform/bridge just fine?

翻譯年糕

Thor Johnson
2019-02-07 11:30:52

Richard Shapiro
2019-02-07 11:35:39

Shreyo Bagchee
2019-02-07 11:47:00

Barry Masterson
2019-02-07 11:47:30

Barry Masterson
2019-02-07 11:48:44

Shreyo Bagchee
2019-02-07 11:49:30

Barry Masterson
2019-02-07 11:50:01

Robert Silvers
2019-02-07 11:52:34

Robert Maefs
2019-02-07 12:22:28

Keenan Beblo
2019-02-07 12:24:18

Robert Maefs
2019-02-07 12:25:38

Jesse Stenner
2019-02-07 15:49:40

Jesse Stenner
2019-02-07 15:49:41

Darren Tarbard
2019-02-07 20:09:12

Georgios Kolotouros
2019-02-07 22:41:46

Nick Williams
2019-02-08 02:13:06

Nick Williams
2019-02-08 02:13:39

原文網址 Keenan Beblo
2019-02-06 23:39:01

Well day one down. Learnt a lot. Thank you everyone! Tried to print a bed full of minis.

The big one circled in red didn’t print ? came off of the supports. Should I have used medium supports? Or just more of them?

I also learnt not to have the base of the model touching the bed haha a lot of them have some of the base cut off. I should have rested the entire model on supports.

Lastly I ran the Prusa and printed a PETG cover for the VAT. Keep it safe while I’m at work!

翻譯年糕