Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I saw someone state they were using laminate sheets to replace the FEP. Can someone confirm that it's working for them and is it more cost effective then buying the FEPs.

翻譯年糕

Dumb question. I'm having issues with prints. I have 11 small items on the plate. Tow of them fail. they are in the same corner. I've releveled the bed just recently and still the same issue. The base is created and even the start of the supports however they are not staying stuck to the supports. The other parts look good and break away form their supports just fine. Not too easy but not too hard. Resin is Syria blu. I adjusted my settings for it as i had it too short for the cure time on it. Now all but those two or single spot about the shape of an L isn't holding. Thoughts?

翻譯年糕

Ugh had a fail last night went to clean it up and it just wouldn't let go of the fep. Gave up and drained it and looking at the screen I see the tell tale sign of a leak and cured resin. Thankfully it wasn't much but enough to need the razor blade and a slight soaked ipa towel to clean it off. Would have panicked again but as usual this group has been a great help.

翻譯年糕

The plasitc scraper i got with my phonton finally died. Can i use a plastic putty knife on the FEP to remove cured resin or am i stuck emptying the vat and using IPA?

翻譯年糕

Done

做完了

· 查看原文 · 為此翻譯評分

Two more to paint

翻譯年糕

Morning All. Been watching the group since I got my printer and alot of things have helped from reading everyones posts. I have been working a project to create some Catan tiles, minis, and a few items for the kids. I have been having awesome success as of late and been printing the tiles non stop. I have stayed with AC resin so far however i have some elegoo to play with as well as some Blu. I have seen many state that Blu needs to be pretty warm to work well. I assume it's because it sticks really well is this correct? The room i have run my printer in is about 70-76f. That's a bit lower then what most here have posted. 30C - equals about 86f. That's a pretty big difference. I"m looking to play with once my my AC aqua blue is out. Is it necessary to have it warmer or amy i going to have issues with getting it off the FEP / B
uild Plate?

翻譯年糕

Any chance anyone have a stl file for golf clubs / and or bag?

翻譯年糕

All three are printed at the same time. Vertical. Supports are the sides and even the deformed ones they still had supports. Any thoughts? The one good one with a line is just a top off with clear resin near the end

翻譯年糕

Got my printer about 1 month ago. Printed the cube with no issues. Had a few failures, ok a lot of failures as i learned certain things about the printer and how to get them to print. Pretty happy with getting it working now.

翻譯年糕