Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hey guys. Can anyone help me. I releveled the bed prior to this. Is the a reason why one whee did not print? The face of the wheel was laying loose in the vat.

翻譯年糕

Some prints

翻譯年糕

Hey guys. Just thought I’d post a tip after a week. ( not sure if it’s been posted) I’ve had quite a few failed prints over the last week. The first few I would remove the resin and then clean it off the vat. It was quite a mission trying to get it off and not damage the vat. How ever I started removing it with the resin in without taking the vat out. Comes off way easier and with less force.

翻譯年糕

Success! Thanks to those who gave advice etc first fully successful print

翻譯年糕

Painted the motor

翻譯年糕

Some of my successful prints

翻譯年糕

Hey guys I really need some help. As posted yesterday, I had half a successful print. Half the items ( the smaller parts) printed perfectly but the body I was printing ( car body size of a Hotwheels) didn’t print at all and is stuck on the fep. This is the 3rd time now. I re leveled the bed today again . Is it maybe supports? Or settings. I’ve attached a photo of the parts that printed .

翻譯年糕

Hey guys I need some advice... I just changed my resin to the black one. I did a print but only my very small items printed but the rest is sitting on the fep. I’m printing at 0.02 I tried the settings online and the default settings just at 0.02 both have the same issues. Should I re level the bed and try again?

翻譯年糕

Hey guys! Newbie here. Just got my photon on Friday and started doing some tests. Had a few good and bad results. Here are some photos. Still a lot to learn but it’s quite exciting. I seem to be having an issue since printing these. I re printed these wheels but two parts stayed on the vat while the others printed perfectly. I did re align the bed before but should I do it again to avoid this?

翻譯年糕