Hey guys, just took delivery of a photon. Here’s my very first prints on it. The little Krang things were first. As you can see there is very fine horizontal lines on both of these. I was printing at 0.01 per layer with 7.5s exposure and 4.5s off. I set 8 base layers with 140s per layer just to be sure they would adhere to the build plate. Just used the stock photon slicer to add supports and slice.
Second print was a batch of teeny tiny starfighters with the same settings. These came out extremely well.
Resin being used on both is the anycubic green.
I’m running the stick firmware that came on my photon as I was too excited to set it up and test it out before changing any software on the device....
Anyone got some tips how I can avoid these horizontal lines on teeny tiny monsters?
Different orientation of the model, different resin, different settings, Install the AA firmware on my photon....?
Any help would be much appreciated.
:)
翻譯年糕
Bob Deblier
2019-06-08 21:26:11
Bob Deblier
2019-06-08 21:28:45
Paul Scott
2019-06-08 22:18:42
Bob Deblier
2019-06-08 23:39:42
Paul Scott
2019-06-08 23:59:05
Bob Deblier
2019-06-09 00:07:22
Paul Scott
2019-06-09 01:02:08
