I didn't see a direct answer to this. I've leveled the bed a few times, definitely didn't have it perfect the first time, could only print on a third of the bed successfully, but hey, it's learning attempts.
I redid the level, finally ran the test cube, and it printed in whole, but the back corner of it collapsed. Not the support raft, but the framework. It collapsed it seems, after printing, because the later layers without alternate support did stay connected. essentially the bottom two square edges of the back left is broken, but the rest came out fine and whole. Base layers did print and held firm to the build plate.
My question is, is this ok? Is it normal for that test print to break in some spots or should it print flawless from the provided slice?
翻譯年糕
Sean Croteau
2019-07-30 08:06:16
Scott Pavlich
2019-07-30 08:45:03
Sean Croteau
2019-07-30 09:17:46
Sean Croteau
2019-07-30 21:27:28
Scott Pavlich
2019-07-30 22:05:41
Sean Croteau
2019-07-30 22:06:45
Scott Pavlich
2019-07-30 22:15:43
Sean Croteau
2019-07-30 22:30:09
