Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Okay so here is my issue. Siraya Blu always prints out with the side facing the build plate being warped and with bulges around where the supports are. I've tried printing with it tilted, it comes out bent. I've tried decreasing exposure, I get support failure. I've tried increasing exposure and I lose too much detail and the warping remains. These parts are still salvageable but only if I sand the warped side flat which takes more time. Suggestions? This was printed flat with supports underneath. Mostly medium supports with a few heavy mixed in since I printed solid.

翻譯年糕

taking suggestions. gonna try a new resin once my siraya blu runs out. need something easy to work with, with high strength to be used in mechanical parts, and holds detail really well. color doesn't matter to me as it will be painted over. thoughts?

翻譯年糕

Anyone know why Siraya Blu bulges around support contacts and how to prevent it? Hopefully something that doesn't involve printing at an angle. I almost always get bad prints like that. Flat faces ending up bending for example.

翻譯年糕

So people have been saying that curing in water has little to no effect, but I've found it MUCH less likely that prints cured in water will come out feeling sticky and tacky. there's a theory that using warm water while curing also increases strength, especially for siraya blu. Anyone else have any experience doing this? i'll say I definitely haven't had to do any post-cure cleaning since I started doing this. Before I'd still get tacky prints where a second cleaning after curing was needed, but now I don't.

翻譯年糕

Does anyone else find siraya blue not very good at printing at angles? like its either print straight up or turn a full 90 degrees. no alternatives.

翻譯年糕

is there any software anybody recommends for vr-sculpting? i have an oculus rift and would like to try it out for creating and editing D&D minis, but i haven't really looked much at programs.

翻譯年糕

Bit difficult getting a good picture of a translucent resin but here we go. What is the hivemind's interpretation of this? I used the 50u.B100.2-20 test file. What settings is this showing would be best?

翻譯年糕

So I tried the exposure test for the Siraya Blu resin and it came out as a blank square. What am I doing wrong? I used the file labeled resin-test-50u b100. 2-20. I assume you just use the file from the layer height you normally print at right? Like the 50u is for printing at 0.05mm layer heights, right?

翻譯年糕

so im playing with the idea of lowering my layer heights for my siraya blue prints from 0.05 to 0.03 or even lower. generally that means lowering my exposure times right? thinner layers require less time to cure? anybody tried this with any success? im just losing out on some details im noticing on a model and i wanted to help bring them out a bit more.

翻譯年糕

Original photon owners, what settings do you guys find works best for Siraya Blu? Ball supports, times, etc? Photon S owners need not comment.

翻譯年糕