Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Re: my failed prints, I found a youtube video showing the same problem. None of the comments solved the issue. Any ideas?

翻譯年糕

A new failure!

This base came out with a line through it. I did pause the print over night, so I assumed that was the large line. BUT there are also some smaller lines underneath that big obvious one. Any idea why?

This Photon hasn't been as plug and play as advertised.

So far it's been...
Fail 1: warped interior to the test print.
Fail 2: test print did one layer then reset to home screen and stopped, that layer on the FEP.
Fail 3: test print did one layer then reset to home screen and stopped, on build plate this time (new USB).
Print 1: An orc that came out flawless! This made me suspect test file corrupted. (Picture below, no issues)
Fail 4: A mind flayer prints layer one and resets to home screen, same as #3 (same USB as the Orc)
Fail 5: The orc's base comes out near perfect except for those lines running through the middle (yet another USB).
Does that trail of clues lead anywhere? Bad motherboard? Bad power supply? Faulty USB cable?
I unplugged the machine to flush its memory, and I'm going to simplify file names and reduce the number of files on each USB. If that doesn't work I give up and will ask Anycubic to replace it.
Settings seem well within normal range. USB cable inside seemed to be attached fine. Still need to try plugging in directly to the motherboard. .18 firmware. Leveling seems good, but I'll try that again too. 翻譯年糕

2nd test print fail. (1st test print fail in the 1st comment.) This time it printed the bottom layer and then stopped. Hit print, walked away, came back a little while later, and the interface was back on the home screen. Just not doing anything. Just stopped after 1ish percent. Latest firmware, after market USB. Standard settings for the test print. Warm room.

Edit: .18 firmware I meant; the one that was recommended.

Any thoughts?

翻譯年糕

Thinking of getting an Ender 3 for big terrain pieces. Anyone have one? How is it?

翻譯年糕

Hey all and thanks for the add! Just got my photon in the mail and set up. The first test print came out like this-- the middle bar is missing / appears melted, with a fair amount of flash.

Current theories include: fep too tight, crappy anycubic usb, botched bottle of green resin.

I'm very confident in my leveling, but will try to relevel as a test case. Switching usb and updating to .18 firmware.

Before I waste more resin, can anyone come up with a good theory why this would have happened? Why one center bar is messed up but the rest of the model, along all those same layers, is fine?

Thanks! Always intimidating to ask for help. This is my first foray into 3D printing. If you can point me to some kind of cheat sheet of common problems and their fixes, that'd be appreciated and probably keep me from posting too many failed prints! :)

翻譯年糕