So my first photon print went out as a dud.
?
The file I used was the one below, but I did not use any supports at all and I used the green any cubic resin that comes with the printer.
On my prusa she prints fine without any supports whatsoever and printed straight up with no lean. All that was in the photon at the end of the print was her base which had popped off the build tray - and nothing else. It looks like it made it through a few layers then came off the build plate. To calibrate the 0 layer I used the technique where the resin vat was in the photon (not the paper layer Height method) and you adjust it snug and then back it off 0.3mm to set up the print bed. Exposure time 8 seconds at 0.05 layer height. Thoughts/Help welcome!
翻譯年糕
Scott Thurston
2019-05-26 14:53:05
Scott Thurston
2019-05-26 14:53:41
Scott Thurston
2019-05-26 14:54:20
Bob Deblier
2019-05-26 15:02:44
Jim Brown
2019-05-26 15:04:56
Jim Brown
2019-05-26 15:06:22
Scott Thurston
2019-05-26 15:09:23
Scott Thurston
2019-05-26 15:11:02
Jim Brown
2019-05-26 15:19:43
Scott Thurston
2019-05-26 15:21:31
Jim Brown
2019-05-26 15:21:32
Scott Thurston
2019-05-26 15:24:36
Jim Brown
2019-05-26 15:25:09
Tamás Lehoczky
2019-05-26 16:54:40
Joel Reid
2019-05-26 18:08:41
Joel Reid
2019-05-26 18:12:45
Susan Sioux Mercer
2019-05-26 20:31:37
Nick Porterfield
2019-05-26 22:00:02
Jim Brown
2019-05-26 23:41:32
Jim Brown
2019-05-27 00:04:23
Jim Brown
2019-05-27 08:49:24
Jim Brown
2019-05-27 08:55:45
Jim Brown
2019-05-27 08:55:52
Susan Sioux Mercer
2019-05-27 09:27:57
