Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Myrobot Stuff
2019-06-09 17:32:30

What should I trust, the before slincing views or after slicing view ?

In the first one my volume seems to not been full there is weird supports inside but on the sliced views the stencil seems ok not support visible and my cylinder seems full not "allow".

Chitubow 1.4.0

翻譯年糕

Andrey Sabrev
2019-06-09 18:03:42

谢信福
2019-06-11 15:39:16

Andrey Sabrev
2019-06-11 15:41:00

原文網址 Myrobot Stuff
2019-05-25 19:30:42

Hi, any advice about that "bleeding" every where in holes, corners ?
Thought about over-exposed,or under IPA cleaning, something else ?
This is siraya BLU at 22°C.

(also notice that resin was kind of "curing by itself ", some was cured on top of the plate wich is opposite of uv light source, print made by night, no external light).

翻譯年糕

Robert Maefs
2019-05-25 19:45:25

John Good
2019-05-25 20:36:02

John Good
2019-05-25 20:39:11

Robert Maefs
2019-05-25 21:00:39

Anthony Pham
2019-05-26 10:23:51

Robert Maefs
2019-05-26 11:07:54

原文網址 Myrobot Stuff
2019-05-24 01:07:09

Hi all !
Not sure how to interpret it yet.
What do you think ?
Also I read somewhere that I have to twice the exposure test result as the good exposure to use on chitubox. But I'm not sure because it won't fit with the official recommendations. (This is BLU by Siraya.)
Thank's

翻譯年糕