Hello! Running into an issue with leveling. Using the paper method, following the steps laid on in the videos linked in the FAQ - lowering it carefully all the way down to the glass while loose, applying pressure to both sides, and tightening. Getting it tight, but then when I go to lift the platform back up, I'm noticing the back (toward the Z shaft) is lifting first. As in, for the first .5mm, the back edge is off the glass, and the front is still contacting.
Also, even when tight, the platform will swivel a tiny bit - it doesn't wobble (appears to stay level, aforementioned issue aside) but it does swivel horizontally. Not all the way around, just a bit. Is that normal?
About 75% of my prints are failing to one degree or another, and I suspect this is at least part of the issue. Do I need to disassemble the platform joint? Any other suggestions?
Thanks in advance!
翻譯年糕
Sercan Güzel
2019-03-19 23:48:13
Zena Andreou
2019-03-19 23:49:49
Jerod Jarvis
2019-03-19 23:55:08
Sercan Güzel
2019-03-19 23:56:09
Jerod Jarvis
2019-03-19 23:57:29
Jerod Jarvis
2019-03-19 23:57:59
Sercan Güzel
2019-03-20 00:00:12
Jerod Jarvis
2019-03-20 00:01:33
Sercan Güzel
2019-03-20 00:07:28
Zena Andreou
2019-03-20 00:08:46
Jerod Jarvis
2019-03-20 00:14:41
Jerod Jarvis
2019-03-20 00:15:52
Björn Ståhlnacke
2019-03-20 00:18:32