Anycubic Photon Printer Owners 造訪社團 » LCD

Any idea what would cause this? Like 70% of the supports on the bottom section decided not to print. Still surprised the print held up tho. Would an LCD problem cause that?

P.S any tips on improving mini quality I've been getting solid meh results. I've been using elegoo gray

翻譯年糕

Help !
I just had a resin leak in my fep...
Changed everything cleaned up, got the baked resin off the lcd. Re-leveled and everything was working fine.

Now the touch screen is unresponsive...
Lit up but nothing is pressing.
And my plate is in the resin, i can't raise it.

翻譯年糕

After almost getting heart attack when replacing LCD I found a piece of dust like that got though. Do you think it makes a great difference? Replacing it was so traumatasing that I don't want to touch it anymore ?

翻譯年糕

At the risk of sounding stupid...

When releveling the build plate, we use a piece of paper to achieve level, as well as establish an offset from the LCD. This becomes Z=0. Has anyone seen what that dimensional offset is supposed to be? That is, a piece of paper mics to about .1mm (with mic squish it's a little less, and naturally there's some variability in paper thickness). And I'm assuming Anycubic chose that as paper is ubiquitous worldwide, not everyone has feeler gauges. So, is .1 mm intended to be the offset from the LCD, and therefore Z=0?

翻譯年糕

Where does everyone go about purchasing their replacement LCDs? I figure I should probably go ahead and have one on hand before the one that came in my photon dies.

翻譯年糕

Having issues with new replacement LCD screen. Seems to be installed properly but the UV test doesn't show any hint of the UV light getting masked by the LCD. Just a blanket of UV light across the whole screen area coming through.

Any ideas? :/

翻譯年糕

How do y'all clean cured resin off your LCDs? I've heard of using acetone to dissolve it, but I'm a bit worried about damaging the screen with that.

翻譯年糕

Hi all! first of all, thanks for accept me in this group.

I have 3 anycubic photon, all works well, except one that it's lcd screen starts to make strange things. I replaced it with an elegoo lcd and the elegoo lcd stays purple, not black or totally open, purple, like if it's black part has an opacity of 40%. The same happens with an Anycubic lcd screen.

I put the previous lcd screen, the bad one, and it shows hardly the calibrating rectangle, but it tries to draw the rectangle, the others didn't.

What can I do to fix it?

Thanks in advance

翻譯年糕

So as some of you may recall form yesterday, I posted a pic of hardened resin on my LCD.

I was able to get it cleaned off (thanks for all the tips)

However... this morning my print had a HUGE hole in it and was missing one of it's feet! :(

I removed the basin, and guess what? More hardened resin.... this time green.... I think my basin is leaking, though it doesnt feel wet at all on the bottom of the ... the...uh...clear plastic bottom of the basin. (cant think of what it's called)
But the LDC appears to be fine as far as it's lights all go. (the last pic is of my LDC lit up without the resin on the screen)

翻譯年糕

I know it's a bit counter intuitive, but is there any sort of lcd protector, like a peel and stick ? Just to protect from scratches and drips ? Only a week in and I'm noticing i could use something like that. Afraid it would interfere with prints though.

翻譯年糕