Hi everyone,
Looking for some help please!
So my machine arrived.
?
I set it up as per the instructions.
Levelled the bed with a sheet of paper, also levelled the machine itself.
Stuck the USB pen in that came with the machine and it refuses to read it.
So i put that usb pen in my computer and it reads fine. Copied the photon.photon file onto a couple mord usb pens i have and went back to the machine. After a couple of attempts i got one of them to load the test model.
Loaded the model a then poured the contents of the resin bottle that came with the machine into the vat.
Set it away and everything appeared to be going well.
The layer appears on the screen, as does thr percent complete and the current slice number.
It had roughly 1400 slices, i left the machine to run on it’s own and came back after about 500 layers,
Id set up a webcam and had been watching each layer, the bed moves up after each layer, then back down, as i would expect it to.
After the 500ish layers the bed was now sufficiently far out of the bed that i could see that nothing has stuck to the bed.
I could see through the liquid resin that the lcd screen was showing the current layer so im pretty confident that the screen isnt the issue.
At this point i cancelled the print.
I havent cleaned it out yet, but i can see that only a couple of layers have cured and appear to be in the bottom of the vat. There is nothing floating around in there.
Any ideas why this print might have failed?
Bed not level?
Bad batch of resin?
Just a failed print and i need to start again and get used to this happening?
Any help would be greatly appreciated.
Thanks.
翻譯年糕
Horris Borris
2018-12-03 05:00:11
Craig Bragg
2018-12-03 05:27:22
Michael Supraholic
2018-12-03 05:27:29
El Ner Endem
2018-12-03 05:31:56
Steven Tooze
2018-12-03 05:36:09
Steven Tooze
2018-12-03 05:36:28
Eric Jensen
2018-12-03 06:17:19
Dave Corbett
2018-12-03 07:32:24
Steven Tooze
2018-12-03 07:47:15
Dave Corbett
2018-12-03 07:48:47
Chris Sutherland
2018-12-03 16:20:27
