Anycubic Photon Printer Owners 造訪社團 » TIP

My Photon is having problems. When I start a print it does a few layers then just stops no alarm, no error message then it resets itself. Changed flash drives multiple times and load newer firmware. Still no change. Anyone have any ideas or suggestions?

翻譯年糕

Hello everyone, just got my photon a few days ago, and I've had great success with printing normal 28-32mm minis, minus a few user errors causing failures, but I've now tried 6 or 7 times to print a larger model and I keep getting nothing but instant fails stuck to the FEP, I've tried releveling the build plate several times but still nothing, any tips or suggestions would be greatly appreciated!

翻譯年糕

Anyone have experience with monocure flexible resin? I have had eight failures so far using multiple exposure times using a layer height of 0.05mm. what are everyone's settings?

翻譯年糕

Hi Everyone. I need help. I have been churning out small prints since I got my printer. However, when I tried to make multiple prints or large prints, the print starts to pull away from the print bed. I have re-leveled the bed but the issue remains. I am using the Elegoo gray and the setting are the factory setting for the printer.

翻譯年糕

Looks like second time is the charm. Must have had the plate too high, but I'll recheck it in the morning. Thanks for the advice and tips!

翻譯年糕

So I'm new to the 3D printing scene and I haven't got my machine in yet is there any tips you guys can give me for starters also what brand of resin should I use what's the best

翻譯年糕

Hi, new member here. My Photon arrives on Friday.
I own an Ender 3 but decided I needed more fine detail.
My main printing subject is HO scale vehicles (trucks in particular) , any veteran print masters care to share their tips for this subject?
Also, being a big fan of Cura and it's print preview system, I'm after the nearest equivalent for the Photon. I've managed to download the Anycubic slicer and find the preview a bit difficult to read. Any slicer recommendations?

翻譯年糕

After over a year with my photon I did a complete strip and clean, some new settings and getting better than ever prints
Monocure rapid grey with maybe 10% flex mixed in
Auto supports with manual adds & deletes
Light supports at 55%
90s base
10s exposure
Washed in monocure resin away then in a sonic bath with resin away
Camera shows up support tips I couldn't see by eye (I'm getting old and blind) so will need to get decent magnifier and clean up those tips

翻譯年糕

Hey Gang - newbie to the group. Got my printer last week. Went through the usual learning curve, and successfully printed the cubic test file thingy off the thumb drive yesterday. So far, so good, but every time I try printing any of my own files, I get a "Memory error code M_400" I've tried multiple files, all with the same results. Anybody know a fix?

翻譯年糕

*Resin vapor question. I'm making a vent to outside. Does anyone know the vapors density vs "air"? It seems to me that it is dense "staying lower to the ground" .
Multiple printers here served by one vent hood. So I'm thinking hood behind the printers?
I'm tired of buying air scrubber cartrages and with the hood trying for an adequate extraction (not try to vent out all my ac).

翻譯年糕