Anycubic Photon Printer Owners 造訪社團 » EVA

These things are printed in BlueCast Crea at 50 um 14 sec. They are 4 cm in diameter, supported in Meshmixer, fixed in PhotonFileValidator. Good fine detail overall, but there are issues with keeping circular shape - the solid ones are slightly elongated while the filigree ones are almost correct. Probably there are not enough supports to keep the shape of the solid ones fixed, I don't know... Any idea, please?

翻譯年糕

nueva figurilla a falta de algun detallito. un dedo gordo y cosillas en el traje

翻譯年糕

Prueba de la nueva resina @bluecast CR3A muy buena definición.

https://www.instagram.com/p/B16faf4AsHA/…

翻譯年糕

Has anyone else had problem with Photon Slicer suddenly starting use Japanese instead of English?

Or I guess switching language without you even opening the settings, doesnt have to be English to Japanese, Danish to Swahili or Dutch to Klingon would be relevant as well.

翻譯年糕

Hi.

I new with the Anycubic Photon and I wanted to know if there was a chance to elevate bed after few layers to see if the print is correctly attach to the bed.

Thanks!

翻譯年糕

Does anyone have any settings for Printing on the Bed with PrusaSlicer please? I've tried setting 'Raise Height' to 0mm, but I get 'Elevation is too low for object' error. Can't any advice online. Thank you!

翻譯年糕

hi..did someone tried the zortrax z suite on the photon?, they opened to third party printers..it looks pretty good. apparently it includes infills and adding a hole to the piece at the same time (unbelievably chitubox doesn't, and coming from a mechanical hackground this looks important). and also XY oversize/undersize compensation.

翻譯年糕

So after trying a few times, I'm at a loss as to why this is happening. Using Monocure Rapid White in a cold house (~13c, no heater yet).
What I've tried:
-Using the settings from the resin wiki (60s bottom, 5 bottom layers, 11s layers), original settings were chitubox defaults
-warming up the build plate (with a hair dryer on max) and resin (hot water bath) before attempting to print
-cleaned the build plate with pure IPA (and make sure it evaporates before starting the prints).

Model being printed: https://www.myminifactory.com/…/3d-print-nine-tailed-demon-… (41% scale)

Notes about my printer:
Can't remember which firmware version (should be latest)
Cardboard tube is filled with carbon pellets to assist with the smell
Raspberry Pi 0W being used as a wireless flash drive

翻譯年糕

So I bought a Photon and, after waiting an unreasonably long amount of time to actually receive it (which is unrelated, but adds to my frustration), I started printing with it. The quality was great, everything was working like I expected it to, but then within three days of getting the printer I'm having a Z-axis malfunction, where it just won't move.

I've looked online and have seen a lot of similar issues, but in all of them the printer's fans and LCD are also malfunctioning. In my instance the fans and LCD work fine, and it's just the Z axis that won't move. I've tried power cycling and updating the firmware to no avail.

It might be relevant to note that I had a print going while I was out and about, and when I returned the print appeared to be partially-complete, still attached to the build plate, and the build plate was all the way up at the top of the Z axis.

I have relatively little experience in troubleshooting hardware, so how would one go about figuring out what the issue is?

翻譯年糕

Looking to build a fume hood/evacuator. let me see your solutions.

翻譯年糕