So after trying a few times, I'm at a loss as to why this is happening. Using Monocure Rapid White in a cold house (~13c, no heater yet).
What I've tried:
-Using the settings from the resin wiki (60s bottom, 5 bottom layers, 11s layers), original settings were chitubox defaults
-warming up the build plate (with a hair dryer on max) and resin (hot water bath) before attempting to print
-cleaned the build plate with pure IPA (and make sure it evaporates before starting the prints).
Model being printed:
https://www.myminifactory.com/…/3d-print-nine-tailed-demon-…
(41% scale)
Notes about my printer:
Can't remember which firmware version (should be latest)
Cardboard tube is filled with carbon pellets to assist with the smell
Raspberry Pi 0W being used as a wireless flash drive
翻譯年糕
Richard Humble
2019-08-25 23:14:08
Trystan Jones
2019-08-26 06:21:11
Richard Humble
2019-08-26 13:40:51
