Photon-S using Elegoo grey. Layer height .02. Bottom layer 10, 50s, no light off delay. Exposures (from top left to bottom right) 6s, 8s, 10s, 12s. Please disregard the quality of the base layers as the 6s was done with supports and the others on the plate (really hard to get off without damaging like the cracked triangle building in the 12s front side).
The shared Resin doc suggestions 14s for elegoo grey at 0.02 height and similar resins at this height (anycubic grey 12s, wanhao grey 11.4s) suggested at higher time values. However, these are all given for the original Photon.
From looking at all sides--sorry for the poor photo quality--I would say 8s is probably the best range. Clarity of back side lines with proper depth and building separation from above, among other things.
So assuming correct times in the document, I would assume the differences comes from the upgraded UV array in the S? This would also suggest that people using the S model do their own resin tests until there are reliable resources for the newer model?
Also, if anyone has a better way to test exposure on the S--since there isn't a resin exposure test available yet--then please let me know. Otherwise I plan to redo these soon when I start using 10% monocure flex100.
翻譯年糕
Patrick Beals
2019-07-09 02:10:55
Nicholas Taylor
2019-07-09 02:59:33
Chad Elstad
2019-07-09 03:49:32
Patrick Beals
2019-07-09 06:07:51
Nicholas Taylor
2019-07-09 12:17:00
Nicholas Taylor
2019-07-09 20:57:38
Chad Elstad
2019-07-09 21:03:40
