Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Having good success with Siraya Blu. But this specific print has some oddities. What usually causes these waves on the bottom? This is the only print this is happening on.

Exposure times? Too little or too much?
Resin viscosity? (Need to heat it more?)
Not enough or poorly placed supports?
Part orientation?

I've tried resin at 21C, .05 layers, exposure 60/13, 70/16, & 90/18

I've tried the same settings with resin at 28C

The STL is a Beyblade level chip for my son.

Over all, the print is fine for him, but I'm just trying to get better at this.

Thanks all!

翻譯年糕

Started printing with Siraya Blu. I can't find any info on its post print temperature resistance (how much heat can a printed part take). Anyone have this info?

Thank you!

翻譯年糕

I've had this printer for a week. After one failed print using the paper leveling method, I've had all successes after doing it the "Flint Read" method (carefully).

I'm just here to say... I LOVE THIS PRINTER!

翻譯年糕