Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Dario Alterini
2020-02-07 07:27:56

Hi everybody, what happened in here? I'm sorry if something about this issue was already posted and I didn't see it. Thank you!

翻譯年糕

Sean Bauer
2020-02-07 07:37:00

Dario Alterini
2020-02-07 07:38:42

Dario Alterini
2020-02-07 07:40:44

Brian Gabriel
2020-02-07 07:43:48

Dario Alterini
2020-02-07 07:48:08

Jonathon Michael Starwalt
2020-02-07 07:52:05

Dario Alterini
2020-02-07 07:55:51

Dario Alterini
2020-02-07 15:07:56

原文網址 Dario Alterini
2019-09-14 16:06:20

Hi everybody, what am I doing wrong? There's something that I didn't understand, because the print miss the sharp edges, everything else it's fine but not the edges. Why? I'm sure it's my fault and I want to understand why. The parameters are from the Google sheet, layer is 0.5, the resin is the Anycubic grey and the orientation is 46°. As always thank you for your support!

翻譯年糕

Elle Heilig
2019-09-14 16:10:20

Heng Ning
2019-09-14 16:10:25

Yasu Tano
2019-09-14 16:11:02

Khoa Truong
2019-09-14 16:11:40

Luke Mason
2019-09-14 16:14:22

Henrik Andersen
2019-09-14 16:14:50

Rebekah Anderson
2019-09-14 16:21:50

Tiernan Messmer
2019-09-14 17:07:03

Pietro Malaguti Abbate
2019-09-14 17:27:09

Gaetano Caico
2019-09-14 20:19:02

Dario Alterini
2019-09-16 21:39:15

原文網址 Dario Alterini
2019-09-12 04:51:18

Hi everyone, since the last time you where incredibly helpful, today I need again your help. I upgrade the Photon with the twin rail and update with the 4.2.18 firmware. I print this two fellows from Berserk to test the AA that I set to 4. I print with the gray Anycubic at 0.5 with the parameters from the Google sheet. My question is, why the AA is more evident in some areas and not in others? What am I doing wrong? As always thank you all!

翻譯年糕

Jarkko Liutu
2019-09-12 04:58:38

Ben Cox
2019-09-12 04:59:35

Ben Cox
2019-09-12 05:00:31

Dario Alterini
2019-09-12 05:18:38

Ben Cox
2019-09-12 05:58:47

Chasen Harris
2019-09-12 06:57:26

Bernardo Muñoz
2019-09-12 23:27:31

Nicolas Tsagarides
2019-09-13 21:23:10

原文網址 Dario Alterini
2019-08-24 06:48:04

Hi guys, what do you think about the second picture? Why is shiny and why there is a loss of details? The shiny side is where the supports were. I use the anycubic grey with the Google sheet 0.5 parameters. Thank you! ?

翻譯年糕