Anycubic Photon Printer Owners 造訪社團 » 用戶發文

hello, I have not lit my photon for 3 months and it does not work anymore.
The uv runs 1 hour and after it does not show anything: /
Someone knows why ?

翻譯年糕

Hi , someone have a older version of xyzware nobel to share ?
With the last maj we can't use it with our photon

翻譯年糕

Annnnd another one , again with 3d okay 16s cure.
Someone tried the vallejo primer with a brush? it is totally unusable ... a simple touch with my finger takes off the paint.
Can not paste the pieces as the primer did not hold ...

翻譯年糕

Hi, someone can try to slice this file? chitu and anycubic crash whatever the angle and the height I use
I would like to know if it's my file or the slicer the problem?

翻譯年糕

a another successfull print , 60mm hero from soulworker with 3d okay resin

翻譯年糕

Hello, changing fep I noticed I had only one plate, and in the video there are two.
How to change it correctly with a single plate?

翻譯年糕

Another failure, I miss 70% of my prints :S. One arm was printed but not the other, yet with the same supports.
And more importantly, I have wobble at legs, about 4CM and always in this place, on half of my print but not all the time

翻譯年糕

how to change a failed print to a successful print ? ?

翻譯年糕

can someone tell me if my supports are good? 4 fails done before

翻譯年糕

3D black resin.
the raven's beak have failed and diablo have some holes.
I hollowed him at 1.00, it's not enough ?

翻譯年糕