Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I apologize if this is the wrong place for this. I'm selling my Anycubic Photon, only used for a few weeks with no mechanical issues. It's a great printer but ultimately resin was not right for my application. I'll throw in 3 spare FEP sheets, lightly used .5L white resin, strainers, and pretty much everything it came with. Asking $300 + shipping.

翻譯年糕

I've been trying to print this large model for weeks. It's getting very close to perfect :) . Last test was at 60 microns, took around 16 hrs, and created manually a "knockout" panel. Warping is down to a minimum.

翻譯年糕

I'm having major warping problems printing this large model. Adding ribs around the screen didn't improve at all. The bottom part is perfect but the top comes out warped everytime. Fun to do industrial red. .1mm layer height. Any recommendations? Maybe printing at .05mm would improve?

翻譯年糕

Anyone try out the Monoprice resin? How'd it go?

翻譯年糕

Anyone ever order resin from imakr.com ? I ordered 9 days ago, not heard anything. I emailed customer support 2 days ago, still nothing. Been a while since I've done any printing!

翻譯年糕

Does someone have a recommendation for a hard resin with low shrinkage?

翻譯年糕

I've heard the term "overcuring" thrown around a lot. What does this mean and how do I avoid it?

翻譯年糕

Printed in 7 hours at .1mm. Model takes up almost the entire print volume. Now I need to order some more resin..

翻譯年糕

6 hours left on this print. Raft is peeling a little on the corner. Do you think it will recover or should I stop it now?

翻譯年糕

Hey everyone. What are your thoughts on an automatic resin drip mod? I think it could be useful for conserving resin and saving prints. It might be simply possible with a solenoid valve, arduino, sensor (capacitive or prox perhaps), and some fluid hardware.

翻譯年糕