This is always a lovely thing to come home to.
It looks like part of the base layer decided to not stick to itself. I noticed the preview screen start to artifact so I shut off the printer and that lump emerged from the vat. So I'm under the assumption its from overheating or some other unknown issue.
Any ideas on what could have caused the bottom part. I'm pretty certain I just need to relevel to fix the bed issue.
Edit:supports are thick I know. That's not my issue here.
翻譯年糕
Stefan Giudici
2018-11-17 11:07:53
Clifford Ang Kai Wei
2018-11-17 11:14:15
Sen Kun
2018-11-17 14:04:30
Ulrich Rüstungjäger
2018-11-18 01:25:34
Sen Kun
2018-11-18 01:38:34
Nick Williams
2018-11-18 01:43:03
Ulrich Rüstungjäger
2018-11-18 01:43:44
Ulrich Rüstungjäger
2018-11-18 01:44:28
Sen Kun
2018-11-18 01:45:09
Sen Kun
2018-11-18 01:46:11
Ulrich Rüstungjäger
2018-11-18 01:47:03
Nick Williams
2018-11-18 01:47:23
Ulrich Rüstungjäger
2018-11-18 01:52:03
Sen Kun
2018-11-18 01:53:41
Ulrich Rüstungjäger
2018-11-18 01:54:21
Nick Williams
2018-11-18 01:55:32
Ulrich Rüstungjäger
2018-11-18 01:55:56
Sen Kun
2018-11-18 01:59:04
Nick Williams
2018-11-18 02:01:01
Ulrich Rüstungjäger
2018-11-18 02:01:39
Ulrich Rüstungjäger
2018-11-18 02:02:21
Sen Kun
2018-11-18 02:03:24
Ulrich Rüstungjäger
2018-11-18 02:03:40
Nick Williams
2018-11-18 02:04:48
Sen Kun
2018-11-18 02:05:52
Steven Molen
2018-11-18 02:08:01
Ulrich Rüstungjäger
2018-11-18 02:11:21
Nick Williams
2018-11-18 02:12:11