Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Evening ladies and gents :-)

Got a bit of a problem. Yesterday did a 12 hour print no problem, today I changed the fie (some items the same as yesterday) and three/four layers in the printer turned itself off and then back on again. Obviously the printing had stopped. Tried it again after cleaning the bed ad checking the resin bath and the same thing happened. Asking here for any advice before doing anymore to the machine.

Thanks in advance :-)

翻譯年糕

Ladies and gents, a quick question if you don’t mind. Are any of the opaque resin light-tight. I’ve got some small street lights I’d like to do and I’d rather not slather them in paint if I can get away with it.

Thanks ?

翻譯年糕

Morning all ? Quick question if I may. Had a problem recently where there’s been literally no adhesion to the build plate and I end up with a thick silhouette of the build. The build plate is level and the Z is down so the paper barely moves. I’ve also lightly sanded the bed and the tank film is fresh (tight as well).

The only thing I can think of is thinner paper ?

Help would be greatly appreciated ?

翻譯年糕

Got a quick question for those in the know ? My prints are starting to go off at an angle (see photo, sides and centre section should be perpendicular to the ruler). Anyone got an idea what it might be? The table it’s on is level, the only thing I think it could be is the print bed isn’t tightened up as much as it could be?

Thanks in advance ?

翻譯年糕