Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Joules McFarland
2019-08-02 02:22:11

Is there a resin that's biocompatible, able to be ran through an autoclave, yet remain flexible?

翻譯年糕

Dylan Hancox
2019-08-02 02:29:22

Johannes Weis
2019-08-02 02:29:52

Dylan Hancox
2019-08-02 02:31:47

Falcon Tom
2019-08-02 02:33:14

Dylan Hancox
2019-08-02 02:33:54

Dylan Hancox
2019-08-02 02:39:09

Johannes Weis
2019-08-02 02:41:35

Dylan Hancox
2019-08-02 02:46:14

Joules McFarland
2019-08-02 07:08:37

Jake Campos
2019-08-06 10:06:39

原文網址 Joules McFarland
2018-10-24 01:47:54

Any recommendations for a starter casting setup? I really want to use my printer to it's full potential and a lot of you have putting out fantastic casts. Unfortunately my HOA isn't keen on a propane forge type set up so electric is is direction I'm starting to look at.

翻譯年糕

Jeffrey L. Deltano
2018-10-24 02:01:32

原文網址 Joules McFarland
2018-09-16 11:40:42

I've leveled and releveled my bed and I usually get prints where the raft is thinker on the front and thinner in the back. Prints themselves seem fine and I haven't really had any failed prints since after the initial learning curve. Any idea what's causing this?

翻譯年糕