Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hello Friends,

I'm looking for a some resins;
-Flexible black resin
-Clear Transparent
-Any Castable

From your experience, what works well with the anycubic ? I've found some resins from the "word file" do not actually print very well fine details that others do with no difficulty.

What are you printing right know that works ?

Thanks !

翻譯年糕

STL for Torture test

翻譯年糕

Torture test

翻譯年糕

Hi,

I made this "torture" piece based on the failures I was getting with the Photon.

I realized "holes" become less and less defined the more exposure time they get.

Isolated details below 0.47mm (470um) are not printed.
Long details with width of 0.047mm (47um) (the printer stated resolution) are printed but end up measuring 0.30mm (300um)

10 by 10mm strutuctures on the corners measure 10.32mm x 10.32mm, and 5 by 5mm structure in the middle measure 4.83x4.83mm

So, on the periphery details are augmented, in the middle they are reduced.

Concentrated details clump together if there is less than 0.47mm (470um) between them. But print just fine is at least 2x 0.47mm in between.

Holes and cuts on the base are never well printed or close to true values.

Unsupported structures print better the thinner they are (strangely,..)

This is a torture test. I was not expecting to get good results, I just want to expose the weaknesses so we can try and find ways to overcome them.

I join in annex the .IPT file and .STL if anyone wants to try to print it. I would be very thankful if anyone can add on this with some knowledge on the subject and possible improvements.

Resin used was Anycubic White.

Parameters were;

Layer: 0.05mm
Normal Expose Time: 12sec
Off-time: 1sec
Bottom Expose Time: 55sec
Bottom Layer: 4

I realize those are long expose times and might adversely quality, again I was not expecting success but assessing the limits.

Thank you.

翻譯年糕

Hi, did any one manage to printwith formlabs dental resin? Quality? Parameters? Thank you very much!

翻譯年糕