Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hello, trying to update the firmware following the instructions. However, after loading the firmware to the USB and plugging it in and turning on the printer there is no Di Di Di initial loading of the code. i can see the other files are there from the print section. any advice? thanks!

翻譯年糕

hello, i am having an issue hopefully someone here can help with. I just changed my LCD after it was only illuminating half. I have the same issue again however. and after the first layer it jumps up and tries to print from 1 cm up. In chitu and photon slicers it looks ok. attached is a screenshot of the slicer. thanks for any help

翻譯年糕

Many questions lately but this forum is helpful. One more question. The printer is jumping about 1 cm between the first layers resulting in failed prints. It zero's and starts correctly but then jumps. I have sliced with chitu and photon and with supports and flat on the platform and the same thing happens each time. any thoughts?

翻譯年糕

Hello, I am using Photon slicer for mac. I've had better results than with Chitu. however, when i offset the part in Z and generate supports the slicer simply ignores this and smashes the part back onto the plate, i can see some traces of supports left however. Any suggestions for how to avoid this? Thank you

翻譯年糕

Dear all, I ran the UV test and this is what appeared. does this mean my LCD is blown? thank you

翻譯年糕

Hello Question here. I am using the photon stock slicer, however when I try to set a Z height for my object to create some distance form the bed, it automatically resets it. As a result my objects are turning out smashed agains the build plate. Any suggestions? thank you!

翻譯年糕

the anycybic slicer automatically repositions the z hight on an object when generating supports. however i have found its does so too close to the bed. is there a way to set the z height when setting supports or to reset after?

翻譯年糕

perhaps silly question, but how do you delete just one object from the photon without clearing the whole bed?

翻譯年糕

Hello guys. I had a problem where my FEP sheet had a small hole. Resin leaked through and cured on the class. I was able to remove the resin on the glass but it appears there is a small crack in the glass now. have any of you had experience with replacing this glass? thank you.

翻譯年糕

Hello All, Suddenly my printer will not read the USB. when I click print i see only black squares. I have tried another USB stick too... Any help very welcome.

翻譯年糕