Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hey guys, I am after some advice.

I am printing D&D minis, flat to the plate. The bases are coming out thin though, as if the mini is starting a mm or two below the build plate, if that makes sense?

Any advice on what I might be doing wrong?

翻譯年糕

Hey folks.

My motherboard replacement finally got here, and in the process of plugging everything I accidentally pulled the lcd cable from the screen end. I am guessing I need to replace the lcd now as well? I can't see a way to reconnect the two.

翻譯年糕

Has anyone had much experience with anycubic customer service? A month and a bit ago my screen stopped working, and we have finally worked out it's the motherboard. I have a card i got with the purchase that says it is under warranty for a year, but customer service says it's only 3 months?

翻譯年糕

Hey guys! I have had my printer for about 6 months, and there have been no issues. Today when I went to print, I am getting a t:100 LCD error. When I try and run the UV detection, I am just getting two rows of lights vertically down the middle. I tried updating the firmware, but the issue is still there.

I have tried emailing support, but they advised me to update the firmware, and attach photos, something I did in the first email.

Any suggestions?

翻譯年糕

I have been printing my 28mm D&D minis flat to the base because the few times I tried 45 degrees they would fail.

Had to change the fep because of a hole in it last night, and thought I would try again.

Success! Hurray!

翻譯年糕

Hey guys I am after some advice.

For some reason my prints with the wanhao clear are sticky even after washing with ipa and warm dishwater. (Separately, not together)

Is there something else I can do?

翻譯年糕

Hey guys, I opened up the anycubic slicer software, and I can't see the grid. I have uninstalled and reinstalled it, and restarted my computer. Any thoughts?

翻譯年糕

Is there a way to add supports without lifting a print off the build base? I am using the anycubic slicer, but happy to look at another one to do supports.

翻譯年糕

Hey guys!

What's the best way to 'glue' together a print that is in pieces? My first thought was to use a little resin and cure it in my UV box?

翻譯年糕

First print success! What layer size do you guys use for 28mm minis?

翻譯年糕