Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi guys. Ive recently changed from Anycubic resin to Monocure Rapid and I seem to be having a few issues with my supports breaking at about the same height each time. I would greatly appreciate any help with this. I have attached three photos to demonstrate my problem. Thanks

翻譯年糕

Hi. would you guys tell me what brand of resin you use. I've allways used anycubic resin but it has recently got very expensive. thanks

翻譯年糕

Hey guys. I was wondering if anyone can help me. Ive had a photon for a few months and successfully printed several miniatures. Just this morning I tried to print a file of six miniatures that Ive done several times before, and after the second layer the Photon stopped and reset itself. I cleaned the two layers off the plate and tried again. Same Thing.Ive retried this several times today using different usb sticks, redoing the files from scratch, everything. I even filter the resin between attemps. Funny thing is that each time i filter the resin there is a layer in the tray that hasn,t stuck to the plate its just sitting in the tray. If anyone can help I would really appreciate it because it was working perfect last night. Thanks heaps

翻譯年糕

Thanks for help

謝謝你的幫助

· 查看原文 · 為此翻譯評分

Ive set the first ten layers to 60 seconds and 8 seconds from there. I'll try the cube first then

翻譯年糕

Hi everybody. I'm new to this group and only owned a Photon for a week but I have a problem if anyone can help please. I've had seven failed prints. When I say failed I mean my prints failed to stick to the plate and ended up a blob of hard resin in the bottom of the tray. I'm trying to print a custom figure from Hero forge. I've checked height settings, tightened everything, filtered resin and done everything suggested by everybody repeatedly. still no luck. should I add a raft ? any suggestions gratefully accepted.

翻譯年糕