Anycubic Photon Printer Owners 造訪社團 » 用戶發文

New issue!! Printer now freezes, sounds a long beep and then restarts!!! Any ideas would be greatly appreciated

翻譯年糕

Evening hive mind. I have a strange issue that i hope someone can help with.
If i run a sliced print using the photon software everything is great, however, if i run a sliced print using chitu box, my PSU starts making a ticking noise whilst the LCD is exposing layers.
The prints are working fine in both cases.
Any ideas why this may be?? Thanks in advance.

翻譯年糕

Perfect print except the face!!!! Arrrggghhh!!! Might be time for new fep as I think it must have got a bit distorted at this point. Even though the odd issue happens, I still love what this printer can do!!

翻譯年糕

A question for the hive mind!!
This morning after a successful print, I have a very strange issue.
I went to start a new print and my printer exposes the first layer, then powers off!! Full printer shuts down and restarts. Any ideas what the cause might be???

翻譯年糕

Frustrating to say the least!!!!
Hollowed model, plenty of support, and tried and tested layer night and cure time etc, but for some reason the resin stick to my fep in random places and causes print fails!! This is a new sheet too. Any help would be very much appreciated.
Does the rain-x trick work to help lower the adhesion on the fep??

翻譯年糕

Quick question folks. Does anyone get issues when printing larger models if they are not hollow? I usually hollow larger models, but have tried to print a couple of objects solid and they have either warped, or stuck to the fep. I will go back to hollowing, but was curious if anyone found a solution to this. (I am aware larger flat pieces stick to the fep and don't release well) thanks in advance

翻譯年糕

Quick group question. After levelli g and tightening my plate, it still rotates side to side. Is this normal or do I have a defective plate? Prints are working fine at the moment. Thanks in advance Quick group question. After levelli g and tightening my plate, it still rotates side to side. Is this normal or do I have a defective plate? Prints are working fine at the moment. Thanks in advance 翻譯年糕

Hi chums. Does anyone have any recommendations for cheap resin suppliers in the UK? Anycubic or monocure rapid. Many Thanks in advance. Hi chums. Does anyone have any recommendations for cheap resin suppliers in the UK? Anycubic or monocure rapid. Many Thanks in advance. 翻譯年糕

This was my first print of a zbrush sculpt. Was not expecting this much detail!!!

翻譯年糕

Has anyone tried using the laminating pouch trick instead of FEP sheets? Interested to see if it works. Has anyone tried using the laminating pouch trick instead of FEP sheets? Interested to see if it works. 翻譯年糕