• 3D列印服務
  • COSPLAY 3D 建模
  • #maker+t=market
  • 1
  • 2
  • 3

Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Scott Avis
2019-08-09 07:42:55

I have something of a mystery on my hands. I am getting globs of partially cured resin coming out with my prints. The prints finish fine but the globs are sitting in the take with the invited resin. Have any of you seen this and know what could be happening?

翻譯年糕

Matthew M Canfield
2019-08-09 07:51:12

Ben Cox
2019-08-09 07:52:59

Scott Avis
2019-08-09 08:02:37

Ben Cox
2019-08-09 08:06:09

Maggie Jenner-Bennett
2019-08-09 08:20:20

Scott Avis
2019-08-09 08:21:28

Michael Horn
2019-08-09 08:37:11

Ben Cox
2019-08-09 08:41:22

Scott Avis
2019-08-09 09:33:45

Scott Avis
2019-08-09 09:40:58

Maggie Jenner-Bennett
2019-08-09 10:31:28

Sha'doe Kai
2019-08-09 10:34:57

Aaron Wiggins
2019-08-09 12:09:17

Scott Avis
2019-08-09 13:45:41

Eivind Husby
2019-08-09 21:41:21

Scott Avis
2019-08-09 22:03:42

Scott Avis
2019-08-13 09:32:57

Aaron Wiggins
2019-08-13 10:27:14

Scott Avis
2019-08-13 12:27:26


原文網址 Scott Avis
2018-08-15 10:06:51

Hi I'm having an issue with zeroing the Z in my printer. I adjust the bed plate down until its basically touching the screen, tighten the set screw so its perfectly level with the screen then I adjust up by .1 increments until the paper is catching but not stuck. I then go up one menu and hit the Z=0 and select yes (since there isn't any no option) However when I start a print the print bed goes down, hits the build plate and stops but I see the set screw keep going until it starts making a slight grinding noise and the arm that holds the build plate hits the vat wall itself. I have been struggling with failing prints over and over and only getting maybe 1 out of 4 prints to succeed. What am I doing wrong to get that noise and flex?

翻譯年糕


 

討論主題

全不選 常用關鍵字