Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I'm having problems printing anything flat on the buld plate. I seem to loose a lot of height and the print layers seem to be leaning over in one direction. I havent got a comera good enough to be able to zoom in and take a photo. I'm building a thin frame for a small scale model. the drawing height is 2.2mm and about .5-.8 thick on the frame wich is about 85mm long. I'm using any cubic translucent green with .05mm layer height once I've worked out the bugs of this print I will print again at .02. Is this a case of Z axis wobble it doesn't seem to happen when things are up higher on supports. The attachment shows what I'm trying to print

翻譯年糕

Chitubox settings question. What is the function of the setting Mirror in the machine settings? Is it for SLA printers that use a laser and a mirror to cure the resin? Has it got something to do with why the writing on my print came out mirrored?

翻譯年糕

Trouble shooters take a look at this fail please, why am I getting resin exposed on the FEP? Why is my FEP blistering and will it effect print quality? On the print; why are the diagonal layer lines showing please, this print also had an exposed resin film that I had to get off the FEP after the print.

翻譯年糕

Hi Folks, new to the Photon machine and not having much luck, first 2 prints failed to stick to the print bed. I have releveled and am about 50% through my third print but the brint bed has slightly turned on the Z axis that is when from the top has turned slightly. I have a couple of questions 1) I've noticed that the print bed remains loose after tightening what stops this bed from turning like it has and not lining up with theprevious exposure. 2) Can I pause the print at anytime lift the print bed and inspect then return to printing?

翻譯年糕

I'm having difficulty with the Mac version of the Anycubic slicing software. I consistently get the spinning beach ball of doom when try auto adding supports. I have to force stop to end it. I'm running mas OS High Sierra version 10.13.6 and the mac version of their slicer offered on the Photon support page marked as a beta version. Any body have any solutions?

翻譯年糕