Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I have an extra back vent i dont need anymore. If anyone is interested. 6 bucks plus shipping.

翻譯年糕

So monocure resins, same settings as anycubic? Im assuming since the anycubic that came with it was translucent and the monocure ones im looking at is gray. Exposure time would increase?

翻譯年糕

ok so earlier in the week i had problems in my print with little ledges on the surface that are flat, that do not show up in the slicer, i ran the web program and clearly it shows they are there, I have tried every resolution and angle i could think of to fix it. with no success, ive attached some pictures, i am truly lost on what i can do to correct the issue.

翻譯年糕

What are the best options for replacing my FEP sheets? I see lots of different thicknesses, also any makeshift builds for a rrsin filter using different material?

翻譯年糕

Alright first I wanna say ive been printing for a very lomg time on fdm printers so I forget how annoying these posts can be so I apologize.

I'm looking for some insight to an issue in my prints. I have lines in my layers of prints going in opposite directions so it rules out bad layers but I am stumped on how to correct this. On the back which scares me it also has lines that I imagine just from looking at it line up with the z-rod. I printed I did not print flat with the base on the bed as i was planning to try and fit multiples on the bed. Any insight would be helpful and appreciated.

翻譯年糕

If a print doesnt finish before I have to leave for the night is it ok to leave in the printer for 12 hours?

翻譯年糕